A 100% filament polyester, TPU elastomer lined weeping forestry hose. Lightweight, easily packed, and handled. The weepage rate is 11.8 to 18.6 oz/ft/minute at 100 PSIG (350 to 550 ml/0.3 m/minute at 700 kPa). This single jacket forestry hose meets or exceeds ULC S-519-1.

Length: Up to 100' (30,5 m). 
 

 

	The hose shall be a single jacket construction with 100% virgin filament polyester.
	There shall also be a minimum of 11.0 filler yarns per inch in the jacket.
	The thickness of the lining shall be 0.011" (279 µm) minimum and it shall be constructed of extruded T.P.U. elastomer.
	The hose service temperature range shall be -60°F to 140°F (-51°C to 60°C).
	FM abrasion test of 1,000 cycles minimum.
	At 300 PSIG (2100 kPa), its elongation shall not exceed 6% of the initial hose length, it shall not warp more than 20 inches (51 cm) and should not rise from the test table.
	The hose shall not twist more than 10 turns per 100 ft (30,5 m) while at 300 PSIG (2100 kPa).
	Minimum service test pressure of 150 PSIG (1050 kPa).
	Minimum proof test pressure of 300 PSIG (2100 kPa).
	Minimum straight burst test pressure of 900 PSIG (6300 kPa).
	The hose while curved to a radius of 27" (69 cm) shall not burst at less than 900 PSIG (6300 kPa).
	The leakage shall be consistent and uniform throughout the length of the hose. The leakage rate per 1 foot of hose at 250 PSIG (1750 kPa) shall be 0.68oz/ft/min (66 ml/m/min) for the 1" (25 mm) and 1.03 oz/ft/min (100 ml/m/min) for the 1˝" (38 mm).
	Meets or exceeds ULC S-519 specifications.