 | The hose shall be of single jacket construction with 100% virgin filament polyester. |
|
| There shall be a minimum of 10.0 filler yarns per inch in the jacket. |
|
| The thickness of the lining shall be 0.015" (381 µm) minimum and it shall be constructed of extruded T.P.U. elastomer. |
|
| If required (optional), the outside jacket shall be treated with yellow ENCAP elastomer, which shall completely encapsulate the jacket fibers and not merely surface coat the jacket. |
|
| The hose service temperature range shall be -60°F to 140°F (-51°C to 60°C). |
|
| FM abrasion test of 1,000 cycles minimum. |
|
| At 500 PSIG (3500 kPa), its elongation shall not exceed 8% of the initial hose length, it shall not warp more than 20 inches (51 cm) and should not rise from the test table. |
|
| The hose shall not twist more than 10 turns per 100 ft (30,5 m) while at 500 PSIG (3500 kPa). |
|
| Minimum service test pressure of 250 PSIG (1750 kPa). |
|
| Minimum proof test pressure of 500 PSIG (3500 kPa). |
|
| Minimum straight burst test pressure of 750 PSIG (5200 kPa). |
|
| The hose while curved to a radius of 27" (69 cm) shall not burst at less than 750 PSIG (5200 kPa). |
|
| Meets or exceeds UL-19 and NFPA 1961 specifications. |
