 | The hose shall be a single jacket construction of 100% virgin spun polyester, DRAFTKOTE™ treated, combined with a special helical interior reinforcement. |
|
| There shall be a minimum of 14.0 filler yarns per inch in the jacket. |
|
| The thickness of the lining shall be 0.030" (762 µm) minimum and it shall be constructed of extruded T.P.U. elastomer. |
|
| The outside jacket shall be treated with DRAFTKOTE™ elastomer which shall completely encapsulate the jacket fibers and not merely surface coat the jacket. |
|
| The hose service temperature range shall be -60°F to 140°F (51°C to 60°C). |
|
| FM abrasion test of 3,000 cycles minimum. |
|
| At 600 PSIG (4200 kPa), its elongation shall not exceed 6% of the initial hose length, it shall not warp more than 10 inches (25 cm) and should not rise from the test table. |
|
| The hose shall not twist more than 10 turns per 100 ft (30,5 m) while at 450 PSIG (3150 kPa). |
|
| Minimum service test pressure of 300 PSIG (2100 kPa). |
|
| Minimum proof test pressure of 600 PSIG (4200 kPa). |
|
| Minimum straight burst test pressure of 900 PSIG (6300 kPa). |
|
| The hose while curved to a radius of 27" (69 cm) shall not burst at less than 900 PSIG (6300 kPa). |
|
| Minimum vacuum test pressure of 25 inches of mercury (84,7 kPa). |
